Part Numbers for Drillco Rebar Eater
Core Bits Used to Install Maxi-Bolt Anchors
Part numbers for Drillco Rebar Eater Bits used with Maxi-Bolts have the following template:
MRE-Diameter Series-Drill Depth
The designation for a Drillco Rebar Eater drill bit which is correctly
sized to install Maxi-Bolt anchors.
The Diameter Series may be one of the following, depending on the diameter
of the stud bolt of the anchor to be installed:
The diameter of the drill bit is larger than the diameter of the Maxi-Bolt
anchor's stud. They are sized to accomodate the sleeve diameter of the
anchor. Nonetheless, all drills, tooling and accesories are keyed to the
stud bolt diameter of the anchor through the use of these Diameter Series
Designations. See Table I
of the Installation Procedure for drill bit diameters
The drilling depth of the bit. Bear in mind that, because the conical nut
on the anchor occupies the bottom of the hole before the anchor is set,
the hole must be drilled deeper than the embedded length of the anchor.
See the third column of Table I
from the Installation Procedure for details.
Recognize too, that the core left by the drill bit may not snap at the
very bottom of the hole. As a minimum, therefore, the Drill Depth should
equal the embedded length of the anchor + the value from the third column
of Table I + one drill bit diameter.